103SW/SW301(K) COVER( 98.4.24 20:44 y[W 2
POWERED SUBWOOFER
103SW/SW -301
1050SW/SW -501
SER VICE MANUAL
?1997-10/B51-5376-00 (K/K) 2295
KnobKnob
(K29-0578-08)(K29-0573-08)RCA pin jackSpeaker terminal
KnobKENWOOD badge(E23-0224-08)(E21-0279-08)
(K29-0577-08)(B43-0302-04)
KnobPower cord bushing
Cloth frame assyWindowPanel *(K29-0576-08)(J42-0234-08)
(B06-1144-08) (B10-3302-08)(A29-)
Slide switchAC power cord*
(S62-0207-08)(E30-)
Note : Refer to SW-900 service manual(B51-4228-00) if you need
the microprocessor information.
* Refer to parts list on page 8.
SPECIFICATIONS
1050SW(SW-501)103SW(SW-301)
Amplifier
Power output150 watts RMS into 4 ohms,100 watts RMS into 4 ohms,
from 20 Hz to 200 Hz, with no from 20 Hz to 200 Hz,with no
more than 0.09%totalmore than 0.09%total
harmonic distortionharmonic distortion
Phase switchingNormal, ReverseNormal, Reverse
Input sensitivity and input impedance
RCA-type jack70 mV (12 k-ohms)70 mV (12 k-ohms)
Push-type terminals1.7 V(15 k-ohms)1.7 V(15 k-ohms)
Supply voltageAC 110 V~120 V (1050SW)AC 110 V~120 V(103SW)
Rated power consumption150 watts110 watts
Speaker
EnclosurePortedPorted
Speaker units12 in (300 mm) polypropylene10 in (250 mm) polypropylene
conecone
Nominal impedance4 ohms4 ohms
Width14.3 in (363 mm)11.8 in (300 mm)
Height21.7 in (550 mm)18.9 in (480 mm)
Depth18.9 in (480 mm) with grille15.6 in (395 mm)
Net weight53 lb (24 kg)40 lb (18 kg)
Since Kenwood follows a policy of continuous advancement in development, these specifications may change without notice. |